【 AUDIO 】

GMAX

GMAX

The product is used to distribute loudspeaker output signals from audio amplifiers to different loudspeakers for selection and control the volume.This product is only approved for connection to loudspeaker outputs of audio amplifiers and inputs of passive loudspeakers.

G-MAX

2-way speaker switch with terminal clamps
(GEN-270)

Features:

  • ● Connect only loudspeaker outputs of audio amplifiers to the loudspeaker terminals AMP INPUT.
  • ● Connect only passive loudspeakers with impedance between 4 and 8 ohms to the loudspeaker terminals SPEAKER OUTPUT.
  • ● Use only suitable speaker cables with a maximum cross-section of 6 mm² for cabling.
  • ● Carefully check the relevant operating instructions of the devices that are to be connected in regards to input and output wiring.
  • ● If these instructions are not observed, the device or connected devices (amplifier or loudspeaker) may get damaged.
  • ● Switch off the power switch of the amplifier before connecting it and do not switch the amplifier on again until you have made all the necessary connections and che¬cked them. Proceed in the same way when changing the circuit.
  • ● Make sure to introduce neatly the stranded wires into loudspeaker terminals to ex¬clude short circuits. Do not remove more than 6 mm of insulation from the speaker line.
  • ● Note the identification for connecting the loudspeaker terminals:
  • ・red = positive terminal
  • ・black = negative terminal
  • ・RIGHT = right terminal
  • ・LEFT = left terminal
  • ● Connect loudspeaker terminals SPEAKER OUTPUT PAIR 1 and PAIR 2 to the speakers.
  • ● Connect loudspeaker terminals AMP INPUT to the loudspeaker outputs of the amplifier.

  • Specifications:

  • Inputs 1x stereo
    Outputs 2x stereo
    Load 60 W per channel
    Loudspeaker resistance 4 - 8 ohms
    Cable cross-section max. 6 mm²
    Dimensions (W x H x D) 225 x 40 x 90 mm